Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
- 6. Exhaust system
   6.1. Service of final system
   - 6.2. Reduction of toxicity of exhaust gases and management of operation of the engine
      6.2.1. Technical characteristics
      6.2.2. System of self-diagnostics (OBD) and codes
      6.2.3. Block of electronic control (ECM)
      6.2.4. Sensor of temperature of cooling liquid
      6.2.5. Sensor of provision of a butterfly valve
      6.2.6. Sensors of a cranked shaft, camshaft, car speed
      6.2.7. Oxygen sensor
      6.2.8. Air stream sensor
      6.2.9. Detonation sensor
      6.2.10. Pressure sensor in an inlet collector
      6.2.11. Replacement of the sensor of temperature of cooling liquid
      6.2.12. Replacement of the sensor of a stream of air
      6.2.13. Replacement of the sensor of oxygen
      6.2.14. Replacement of the sensor of provision of a butterfly valve
      6.2.15. Replacement of the sensor of an angle of rotation of a cranked shaft
      6.2.16. Replacement of the sensor of provision of a camshaft
      6.2.17. Replacement of the sensor of a detonation
      6.2.18. Replacement of the sensor of speed of the car
      6.2.19. Replacement of the sensor of pressure
      6.2.20. System of repeated burning of exhaust gases (EGR)
      6.2.21. System of catching of vapors of fuel (EVAP)
      6.2.22. System of compulsory ventilation of a case (PCV)
      6.2.23. Catalyst
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


3a942d17

6.2.16. Replacement of the sensor of provision of a camshaft

GENERAL INFORMATION

Arrangement of the sensor of provision of a camshaft

The sensor of provision of a camshaft is installed behind the left casing of a gear belt.

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Disconnect the electric socket from the sensor.
3. Unscrew a bolt and remove the sensor.
4. Installation is made in sequence, the return to removal.