Subaru Legacy

since 1990-1998 release

Repair and operation of the car

Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
- 6. Exhaust system
   6.1. Service of final system
   - 6.2. Reduction of toxicity of exhaust gases and management of operation of the engine
      6.2.1. Technical characteristics
      6.2.2. System of self-diagnostics (OBD) and codes
      6.2.3. Block of electronic control (ECM)
      6.2.4. Sensor of temperature of cooling liquid
      6.2.5. Sensor of provision of a butterfly valve
      6.2.6. Sensors of a cranked shaft, camshaft, car speed
      6.2.7. Oxygen sensor
      6.2.8. Air stream sensor
      6.2.9. Detonation sensor
      6.2.10. Pressure sensor in an inlet collector
      6.2.11. Replacement of the sensor of temperature of cooling liquid
      6.2.12. Replacement of the sensor of a stream of air
      6.2.13. Replacement of the sensor of oxygen
      6.2.14. Replacement of the sensor of provision of a butterfly valve
      6.2.15. Replacement of the sensor of an angle of rotation of a cranked shaft
      6.2.16. Replacement of the sensor of provision of a camshaft
      6.2.17. Replacement of the sensor of a detonation
      6.2.18. Replacement of the sensor of speed of the car
      6.2.19. Replacement of the sensor of pressure
      6.2.20. System of repeated burning of exhaust gases (EGR)
      6.2.21. System of catching of vapors of fuel (EVAP)
      6.2.22. System of compulsory ventilation of a case (PCV)
      6.2.23. Catalyst
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment

6.2.15. Replacement of the sensor of an angle of rotation of a cranked shaft

GENERAL INFORMATION

Arrangement of the sensor of an angle of rotation of a cranked shaft

The sensor of an angle of rotation of a cranked shaft (it is specified by an arrow) is installed on a casing of the oil pump about a pulley of a cranked shaft.

PERFORMANCE ORDER

1. Unscrew a bolt of fastening of the sensor and remove the sensor.

2. Installation is made in sequence, the return to removal.