Subaru Legacy

since 1990-1998 release

Repair and operation of the car


Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
- 11. Suspension bracket
   11.1. Introduction
   11.2. Technical characteristics
   + 11.3. The lobby is resistant
   + 11.4. Rack of a back suspension bracket
   11.5. The air self-leveled suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


3a942d17

11. Suspension bracket

11.1. Introduction
GENERAL INFORMATION

Elements of a forward suspension bracket
1 – stabilizer of cross stability
2 – clips of fastening of the stabilizer
3 – steering draft
4 – tip of steering draft
5 – rotary fist
 6 – lower spherical hinge
7 – cross lever
8 – plug of fastening of the cross lever
9 – protective cover of steering transfer
10 – bolts of fastening of steering transfer

Elements of a back suspension bracket (4WD)
1 – stabilizer of the cross
stability
2 – clip of fastening of the stabilizer
3 – draft of the stabilizer
 4 – back cross lever
5 – forward cross lever
6 – longitudinal lever
7 – fastener of a back nave

The forward suspension bracket of independent type consists of a rack of a forward suspension bracket, cross levers, rotary fists and the stabilizer of cross stability. The top part of forward racks fastens to a body, and the lower part fastens bolts to a rotary fist. The stabilizer of cross stability fastens to a beam and is connected by drafts with cross levers.

The independent back suspension bracket consists of a back rack, longitudinal and cross levers, hinges and the stabilizer of cross stability.