Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
- 13. Body
   13.1. Introduction
   13.2. Care of a body
   13.3 Care of an upholstery and rugs
   13.4. Repair of insignificant damages of a body
   13.5. Repair of strong damages of a body
   13.6. Cowl
   13.7. Replacement of the lock of a cowl
   13.8. Replacement of a cable of the lock of a cowl
   13.9. Front grille
   13.10. Front bumper
   13.11. Rear bumper
   13.12. Forward wing
   13.13. Door upholstery
   13.14. Lock, cylinder of the lock and handle of opening of a door
   13.15. Door glass
   13.16. Window regulator
   13.17. External mirror
   13.18. Doors
   13.19. Trunk lid
   13.20. Luggage carrier lock
   13.21. Cable of opening of the lock of a luggage carrier
   13.22. Replacement of racks of support of a back door
   13.23. Back door
   13.24. Lock of a back door, external handle and cylinder of the lock
   13.25. Casings of a steering column
   13.26. Central console
   13.27. Dashboard elements
   13.28. Dashboard
   13.29. Air inlet lattice
   13.30. Forward seats
+ 14. Electric equipment


https://www.etsy.com/shop/LandLamp : http://society-news.25mk.ru


13. Body

13.1. Introduction

GENERAL INFORMATION

The car has the bearing body.

The body is made of the stamped and welded details, including zones a smyatiya in forward and back parts and rigid central part.

Security measures when carrying out welding works

When carrying out the welding and other works connected with a strong iskrovydeleniye near the accumulator location, surely remove the accumulator.

It is forbidden to carry out welding and the firm and soft soldering of details of the filled conditioner. It belongs and to those elements of the car which welding can cause a warming up of details of the conditioner. When carrying out repair and painting works in the drying furnace or in its zone of a warming up, temperature should not exceed +80 °C.