Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
- 13. Body
   13.1. Introduction
   13.2. Care of a body
   13.3 Care of an upholstery and rugs
   13.4. Repair of insignificant damages of a body
   13.5. Repair of strong damages of a body
   13.6. Cowl
   13.7. Replacement of the lock of a cowl
   13.8. Replacement of a cable of the lock of a cowl
   13.9. Front grille
   13.10. Front bumper
   13.11. Rear bumper
   13.12. Forward wing
   13.13. Door upholstery
   13.14. Lock, cylinder of the lock and handle of opening of a door
   13.15. Door glass
   13.16. Window regulator
   13.17. External mirror
   13.18. Doors
   13.19. Trunk lid
   13.20. Luggage carrier lock
   13.21. Cable of opening of the lock of a luggage carrier
   13.22. Replacement of racks of support of a back door
   13.23. Back door
   13.24. Lock of a back door, external handle and cylinder of the lock
   13.25. Casings of a steering column
   13.26. Central console
   13.27. Dashboard elements
   13.28. Dashboard
   13.29. Air inlet lattice
   13.30. Forward seats
+ 14. Electric equipment


3a942d17

13.23. Back door

PERFORMANCE ORDER
1. Open a back door and support it in this situation.
2. Remove an upholstery of a back door and disconnect all electric sockets and a hose of a washer of back glass.
3. Supporting a back door, remove racks of support of a back door.
4. Using a marker, note the provision of bolts of fastening of hinges of a back door.
5. Unscrew bolts of fastening of hinges of a back door and remove a back door.
6. Installation is made in sequence, the return to removal.
7. After installation of a back door check that in a closed position the gap between a back door and elements of a body of the car is identical everywhere.
8. If necessary adjust the provision of a back door for what weaken bolts of fastening of hinges and, moving a door within the extended installation openings, find the demanded situation.
9. Check that the lock of a back door is precisely combined with a shock plate of the lock.
10. Otherwise remove plastic clamps of fastening of finishing of an aperture of a back door.
11. Remove finishing of an aperture of a back door.
12. Weaken bolts.
13. Oreguliruyte provision of a shock plate of the lock of a back door.