Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
- 13. Body
   13.1. Introduction
   13.2. Care of a body
   13.3 Care of an upholstery and rugs
   13.4. Repair of insignificant damages of a body
   13.5. Repair of strong damages of a body
   13.6. Cowl
   13.7. Replacement of the lock of a cowl
   13.8. Replacement of a cable of the lock of a cowl
   13.9. Front grille
   13.10. Front bumper
   13.11. Rear bumper
   13.12. Forward wing
   13.13. Door upholstery
   13.14. Lock, cylinder of the lock and handle of opening of a door
   13.15. Door glass
   13.16. Window regulator
   13.17. External mirror
   13.18. Doors
   13.19. Trunk lid
   13.20. Luggage carrier lock
   13.21. Cable of opening of the lock of a luggage carrier
   13.22. Replacement of racks of support of a back door
   13.23. Back door
   13.24. Lock of a back door, external handle and cylinder of the lock
   13.25. Casings of a steering column
   13.26. Central console
   13.27. Dashboard elements
   13.28. Dashboard
   13.29. Air inlet lattice
   13.30. Forward seats
+ 14. Electric equipment





13.21. Cable of opening of the lock of a luggage carrier

PERFORMANCE ORDER
1. Remove the luggage carrier lock.
2. Remove a seat of the driver and a back seat.
3. Remove the lower finishing of the central and back rack.
4. Remove internal finishing of thresholds from the driver.
5. Take a cable of opening of the lock of a luggage carrier from fastening brackets in salon of the car.
6. Disconnect a cable from the lever of opening of a luggage carrier.
7. Tie a thin long cord to the end of a cable and take a cable of opening of the lock of a luggage carrier in a luggage compartment.
8. Untie a cord from a cable and use a cord for a tightening of a new cable in salon of the car.
9. Installation is made in sequence, the return to removal.