Subaru Legacy

since 1990-1998 release

Repair and operation of the car

Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
- 13. Body
   13.1. Introduction
   13.2. Care of a body
   13.3 Care of an upholstery and rugs
   13.4. Repair of insignificant damages of a body
   13.5. Repair of strong damages of a body
   13.6. Cowl
   13.7. Replacement of the lock of a cowl
   13.8. Replacement of a cable of the lock of a cowl
   13.9. Front grille
   13.10. Front bumper
   13.11. Rear bumper
   13.12. Forward wing
   13.13. Door upholstery
   13.14. Lock, cylinder of the lock and handle of opening of a door
   13.15. Door glass
   13.16. Window regulator
   13.17. External mirror
   13.18. Doors
   13.19. Trunk lid
   13.20. Luggage carrier lock
   13.21. Cable of opening of the lock of a luggage carrier
   13.22. Replacement of racks of support of a back door
   13.23. Back door
   13.24. Lock of a back door, external handle and cylinder of the lock
   13.25. Casings of a steering column
   13.26. Central console
   13.27. Dashboard elements
   13.28. Dashboard
   13.29. Air inlet lattice
   13.30. Forward seats
+ 14. Electric equipment

13.24. Lock of a back door, external handle and cylinder of the lock

PERFORMANCE ORDER

1. Open a back door and support it in this situation.
	2. Take clips of fastening of an upholstery of a back door and remove an upholstery of a back door.
Lock
	3. Disconnect draft from the cylinder of the lock of a back door.
	4. Unscrew two bolts and remove the lock of a back door.
5. Installation is made in sequence, the return to removal.
External handle
	6. Disconnect draft from the external handle.
	7. Unscrew nuts and remove the external handle of opening of a back door.
Lock cylinder
	8. Disconnect draft from the lock cylinder.
	9. Unscrew nuts of fastening and remove the lock cylinder from a back door.
10. Installation is made in sequence, the return to removal.