Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
- 6. Exhaust system
6.1. Service of final system
+ 6.2. Reduction of toxicity of exhaust gases and management of operation of the engine
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment
|
Exhaust system
1 – oxygen sensor
2 – top casing of a pipe
3 – laying
4 – clip
5 – lower casing of the catalyst
6 – top casing of the catalyst
7 – laying
8 – top casing of the left pipe
9 – reception exhaust pipe
10 – top casing of a back pipe
11 – flange
12 – laying
13 – spring
14 – bolt |
15 – top casing
16 – top casing
17 – back exhaust pipe
18 – lower casing
19 – rubber suspension bracket
20 – laying
21 – rubber suspension bracket
22 – muffler
23 – tip of an exhaust pipe
24 – arm (automatic transmission)
25 – arm (2WD)
26 – arm (4WD) |
Forward part of an exhaust system of cars with a turbocharger
1 – laying
2 – top casing of a final collector
3 – final collector
4 – lower casing of a final collector
5 – arm
6 – top casing
7 – clip
8 – top laying
9 – top laying |
10 – laying
11 – forward pipe
12 – lower laying
13 – lower laying
14 – clip
15 – lower casing
16 – laying
17 – laying
18 – top casing of a final collector
19 – final collector
20 – lower casing of a final collector |
Putting special liquid before a rassoyedineniye of an exhaust pipe
Check of a condition of rubber pillows of the muffler
The final system consists of a final collector, the catalyst, the muffler, an exhaust pipe and other connecting pipes, arms, suspension brackets and collars. Final systems fastens to the car bottom by means of arms of fastening and rubber suspension brackets. If one of these details is damaged or deformed by a consequence existence of noise or the vibration transmitted through the car bottom will be.
At repair of final system take the following simple advice:
– begin work with back part of the car and move to forward part;
– apply special means on fastening details to facilitate their removal;
– at installation of details of final system put new laying, suspension brackets and collars;
– at assembly grease a carving of details of fastening by special structure against jamming;
– leave a sufficient and uniform gap between the established details and the bottom of a body. |
|
