Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
- 11. Suspension bracket
   11.1. Introduction
   11.2. Technical characteristics
   + 11.3. The lobby is resistant
   - 11.4. Rack of a back suspension bracket
      11.4.1. Back stabilizer of cross stability
      11.4.2. Longitudinal lever of a back suspension bracket
      11.4.3. Cross levers of a back suspension bracket
      11.4.4. Nave of a back suspension bracket
      11.4.5. Fastener of a back nave
   11.5. The air self-leveled suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


3a942d17

11.4. Rack of a back suspension bracket

Removal

PERFORMANCE ORDER
1. On cars with a body "sedan" remove a back seat.
2. On cars with a body "station wagon" remove the part of finishing closing nuts of fastening of the top part of a back rack.
3. Lift back part of the car and record on supports. Remove back wheels.
4. On models with back brake drums unscrew connections of a brake hose and a brake tube. Take an U-shaped bracket and remove a brake hose from an arm.
5. On models with back disk brakes unscrew a brake hose from a support and remove it from an arm on a back rack.
6. Support the fastener of a back nave a jack.
7. Unscrew nuts and bolts of fastening of the lower part of a back rack to the nave fastener.
8. For simplification of extraction of bolts raise a jack the nave fastener.
9. Support a rack and unscrew nuts of the top fastening of a back rack.

Installation

PERFORMANCE ORDER
Installation is made in sequence, the return to removal. At installation of bolts of fastening of the lower part of a back rack to the fastener of a nave use a jack to move the nave fastener.