Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
- 11. Suspension bracket
   11.1. Introduction
   11.2. Technical characteristics
   - 11.3. The lobby is resistant
      11.3.1. Repair of a forward rack
      11.3.2. Forward stabilizer of cross stability
      11.3.3. Lower lever of a forward suspension bracket
      11.3.4. Replacement of the lower hinge of a forward suspension bracket
      11.3.5. Rotary fist
   + 11.4. Rack of a back suspension bracket
   11.5. The air self-leveled suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


скачать онлайн 3a942d17

11.3. The lobby is resistant

Removal

PERFORMANCE ORDER
1. Lift forward part of the car and record on supports. Remove the corresponding forward wheel.
2. Disconnect a brake hose from an arm on a forward rack and a support. Close a brake hose a stopper.
3. If the car is equipped with anti-blocking system, disconnect the electric socket from the ABS sensor.
4. Apply a tag on the top bolt of fastening of a forward rack to a rotary fist.
5. Note the provision of a rack on a rotary fist.
6. Unscrew two bolts of fastening (the right arrow) of a rotary fist to the lower part of a forward rack (the left arrow – a bolt of fastening of a wire of the ABS sensor).
7. Take the top part of a rotary fist from a rack and establish a rotary fist on a support.

Prevention

If the new forward rack is established, combine a tag on a ledge of a rack and a tag on a fastening bolt to keep a wheel disorder corner.


8. Holding a rack from falling, unscrew three nuts of the top fastening of a forward rack.
9. Lower a rack and take from under a forward wing.

Installation

PERFORMANCE ORDER
1. Establish a rack on a place and by hand screw three nuts of the top fastening of a forward rack.
2. Insert the top part of a rotary fist into a forward rack and fix bolts.
3. Install the ABS sensor.
4. Fix a brake hose on a forward rack and screw it on a support. Remove air from brake system.
5. Establish a wheel and lower the car.
6. Tighten three nuts of fastening of the top part of a forward rack.
7. Check, and if necessary, adjust corners of installation of forward wheels.