Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
- 11. Suspension bracket
   11.1. Introduction
   11.2. Technical characteristics
   - 11.3. The lobby is resistant
      11.3.1. Repair of a forward rack
      11.3.2. Forward stabilizer of cross stability
      11.3.3. Lower lever of a forward suspension bracket
      11.3.4. Replacement of the lower hinge of a forward suspension bracket
      11.3.5. Rotary fist
   + 11.4. Rack of a back suspension bracket
   11.5. The air self-leveled suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


3a942d17


11.3.5. Rotary fist

Removal

PERFORMANCE ORDER
1. Weaken a nut of fastening of a power shaft to a nave.
2. Lift forward part of the car and record on supports.
3. Remove a support, brake shoes, the holder of a support and a brake disk.
4. On models with ABS unscrew a bolt and remove the ABS sensor.
5. Unscrew a nut of fastening of steering thirst for a rotary fist and, using a stripper, take the spherical hinge of steering draft from a rotary fist.
6. Weaken nuts of fastening of a forward rack to a rotary fist, previously having noted an arrangement of the top bolt in relation to a forward rack.
7. Unscrew a coupling bolt of fastening of the spherical hinge to the lower lever of a forward suspension bracket.
8. Using mount, take the spherical hinge of the lower lever from a rotary fist.
9. Unscrew bolts of fastening of a forward rack to a rotary fist.
10. Unscrew a nut of fastening of a power shaft to a nave. Take a power shaft from a nave, taking away a rotary fist from the car.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, the return to removal.
2. Thus the top bolt of fastening of a rotary fist to a rack needs to be established in the same situation, as before removal.
3. Check and, if necessary, adjust corners of installation of wheels.