Subaru Legacy

since 1990-1998 release

Repair and operation of the car


Subaru of Legasi
+ 1.1. Identification numbers
- 2. Maintenance
   2.1. Introduction
   2.2. Technical characteristics
   2.3. Frequency of service
   2.4. Check of level of engine oil
   2.5. Level of cooling liquid
   2.6. Level of brake fluid and liquid of the drive of coupling
   2.7. Liquid for a windshield washer
   2.8. Check of the accumulator
   2.9. Tires and check of pressure in tires
   2.10. Check of level of oil in an automatic transmission
   2.11. Check of level of liquid in the amplifier of a steering
   2.12. Replacement of oil and oil filter
   2.13. Check and service of the accumulator
   2.14. Battery charging
   2.15. Check of the cooling system
   2.16. Check of hoses, tubes and their replacement
   2.17. Check and replacement of brushes of screen wipers
   2.18. Shift of tires
   2.19. Check of a suspension bracket and steering
   2.20. Check of an exhaust system
   2.21. Check of level of oil in a transmission and the main transfer
   2.22. Check of level of oil in differential (the main transfer)
   2.23. Check of brake system
   2.24. Check of the vacuum amplifier of brakes
   2.25. Check of the emergency brake
   2.26. Check of fuel system
   2.27. Replacement of the fuel filter
   2.28. Check and replacement of a driving belt
   2.29. Check of a free wheeling of a pedal of a brake
   2.30. Check of a free wheeling of a pedal of coupling
   2.31. Check and replacement of spark plugs
   2.32. Check of high-voltage wires
   2.33. Check and adjustment of turns of idling
   2.34. Replacement of the air filter
   2.35. Check and replacement of the valve of ventilation of a case (PCV)
   2.36. Check of system of catching of vapors of fuel
   2.37. Check of system of repeated burning of exhaust gases (EGR)
   2.38. Service of the cooling system
   2.39. Replacement of brake fluid
   2.40. Replacement of oil in an automatic transmission
   2.41. Replacement of oil in a mechanical transmission
   2.42. Check and adjustment of gaps of valves
   + 2.43. Main malfunctions
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


3a942d17

2.9. Tires and check of pressure in tires
GENERAL INFORMATION

Measurement of depth of drawing of a protector of the tire

 Depth of drawing of a protector of tires can be controlled by the special adaptation. At achievement of limit wear of the tire it is necessary to replace.

Uneven wear of tires and the reasons which caused it

  Uneven wear:

– wheels are not balanced or disks of wheels are bent;
 – wear of steering draft;
 – wear of a forward suspension bracket.


Low pressure of air in tires.

High pressure of air in tires.

Wrong positive convergence or big disorder.

Wear because of not coaxiality.

Continuous check of a condition of tires will allow to find in due time intensive wear and to eliminate its reason that will allow to avoid more serious consequences.

With uneven wear of tires it is necessary to find the reason of it and to eliminate it (see rice. Uneven wear of tires and the reasons which caused it).

PERFORMANCE ORDER
1. Check tires for existence of cuts, punctures and foreign subjects in tires.
2. Check reliability of screwing up of a zolotnik.
3. Places of leak of air from the tire can be defined by soapsuds.
4. Carefully survey internal lateral face of each tire on existence of traces of brake fluid.
5. The demanded pressure in tires prolongs the term of their service therefore it needs to be checked regularly. Make control of pressure in tires only on cold tires.