Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
- 2. Maintenance
   2.1. Introduction
   2.2. Technical characteristics
   2.3. Frequency of service
   2.4. Check of level of engine oil
   2.5. Level of cooling liquid
   2.6. Level of brake fluid and liquid of the drive of coupling
   2.7. Liquid for a windshield washer
   2.8. Check of the accumulator
   2.9. Tires and check of pressure in tires
   2.10. Check of level of oil in an automatic transmission
   2.11. Check of level of liquid in the amplifier of a steering
   2.12. Replacement of oil and oil filter
   2.13. Check and service of the accumulator
   2.14. Battery charging
   2.15. Check of the cooling system
   2.16. Check of hoses, tubes and their replacement
   2.17. Check and replacement of brushes of screen wipers
   2.18. Shift of tires
   2.19. Check of a suspension bracket and steering
   2.20. Check of an exhaust system
   2.21. Check of level of oil in a transmission and the main transfer
   2.22. Check of level of oil in differential (the main transfer)
   2.23. Check of brake system
   2.24. Check of the vacuum amplifier of brakes
   2.25. Check of the emergency brake
   2.26. Check of fuel system
   2.27. Replacement of the fuel filter
   2.28. Check and replacement of a driving belt
   2.29. Check of a free wheeling of a pedal of a brake
   2.30. Check of a free wheeling of a pedal of coupling
   2.31. Check and replacement of spark plugs
   2.32. Check of high-voltage wires
   2.33. Check and adjustment of turns of idling
   2.34. Replacement of the air filter
   2.35. Check and replacement of the valve of ventilation of a case (PCV)
   2.36. Check of system of catching of vapors of fuel
   2.37. Check of system of repeated burning of exhaust gases (EGR)
   2.38. Service of the cooling system
   2.39. Replacement of brake fluid
   2.40. Replacement of oil in an automatic transmission
   2.41. Replacement of oil in a mechanical transmission
   2.42. Check and adjustment of gaps of valves
   + 2.43. Main malfunctions
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


3a942d17

2.28. Check and replacement of a driving belt

GENERAL INFORMATION

Defects of a driving belt


Check of a tension of a driving belt

Driving belts are located from the forward party of the engine. Depending on a complete set of the car and the engine installed in it, one or several driving belts are used.

Check

PERFORMANCE ORDER
1. Uncover, closing belts, and check a condition of belts for existence of cracks, stratifications and oiling (see rice. Defects of a driving belt). If necessary replace a belt.
2. Check a tension of a driving belt by means of two rulers.
3. The tension of a driving belt needs to be adjusted so that when pressing by a hand thumb on a long branch of a belt the deflection made about 5-6 mm.

Adjustment

Arrangement of bolts of fastening of a casing of a driving belt.

Bolts of fastening of a casing are specified by shooters.

Arrangement of bolts for adjustment of a tension of a driving belt of the generator


Arrangement of bolts for adjustment of a tension of a driving belt of the conditioner


PERFORMANCE ORDER
For adjustment of a tension of a driving belt weaken fixing and, rotating an adjusting bolt, adjust a tension of a driving belt.

Replacement

PERFORMANCE ORDER
1. Weaken a tension of a driving belt and remove it from pulleys.
2. Establish driving belts on pulleys. Thus belts have to settle down precisely on the center of pulleys. Adjust a tension of driving belts.