Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
- 2. Maintenance
   2.1. Introduction
   2.2. Technical characteristics
   2.3. Frequency of service
   2.4. Check of level of engine oil
   2.5. Level of cooling liquid
   2.6. Level of brake fluid and liquid of the drive of coupling
   2.7. Liquid for a windshield washer
   2.8. Check of the accumulator
   2.9. Tires and check of pressure in tires
   2.10. Check of level of oil in an automatic transmission
   2.11. Check of level of liquid in the amplifier of a steering
   2.12. Replacement of oil and oil filter
   2.13. Check and service of the accumulator
   2.14. Battery charging
   2.15. Check of the cooling system
   2.16. Check of hoses, tubes and their replacement
   2.17. Check and replacement of brushes of screen wipers
   2.18. Shift of tires
   2.19. Check of a suspension bracket and steering
   2.20. Check of an exhaust system
   2.21. Check of level of oil in a transmission and the main transfer
   2.22. Check of level of oil in differential (the main transfer)
   2.23. Check of brake system
   2.24. Check of the vacuum amplifier of brakes
   2.25. Check of the emergency brake
   2.26. Check of fuel system
   2.27. Replacement of the fuel filter
   2.28. Check and replacement of a driving belt
   2.29. Check of a free wheeling of a pedal of a brake
   2.30. Check of a free wheeling of a pedal of coupling
   2.31. Check and replacement of spark plugs
   2.32. Check of high-voltage wires
   2.33. Check and adjustment of turns of idling
   2.34. Replacement of the air filter
   2.35. Check and replacement of the valve of ventilation of a case (PCV)
   2.36. Check of system of catching of vapors of fuel
   2.37. Check of system of repeated burning of exhaust gases (EGR)
   2.38. Service of the cooling system
   2.39. Replacement of brake fluid
   2.40. Replacement of oil in an automatic transmission
   2.41. Replacement of oil in a mechanical transmission
   2.42. Check and adjustment of gaps of valves
   + 2.43. Main malfunctions
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


3a942d17

2.33. Check and adjustment of turns of idling

GENERAL INFORMATION

Turns of idling are turns of the engine without pressing an accelerator pedal.

Change of turns of idling of the engine can be caused by several reasons:

 – deposits round a butterfly valve in the throttle case;
 – vacuum leak in the basis of the case of a throttle, an inlet collector or the torn vacuum hose;
 – nespraven ISC valve.

PERFORMANCE ORDER
1. Connect a tachometer to the engine according to the maintenance instruction.
2. Warm up the engine up to the normal working temperature.
3. Check turns of idling of the engine. Include everything electric consumers of the car and again measure idling turns.
4. Turns of idling cope the computer therefore do not rotate the persistent screw of a butterfly valve for installation of turns of idling.
5. In a motor compartment the identification plate with information of control of emission of exhaust gases and the instruction for installation of turns of idling is located.