Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
- 10. Brake system
   10.1. Introduction
   10.2. Technical characteristics
   10.3. Replacement of brake shoes on disk brakes
   10.4. Support of disk brakes
   10.5. Brake disk
   10.6. Replacement of brake shoes of drum brakes
   10.7. Working brake cylinder
   10.8. Main brake cylinder
   10.9. Brake pipelines and hoses
   10.10. Replacement of the regulator of pressure
   10.11. Pumping of hydraulic brake system
   10.12. Adjustment of the emergency brake
   10.13. Replacement of a cable of the emergency brake
   10.14. Replacement of brake shoes of the emergency brake on back disk brakes
   10.15. Additional brake system
   10.16. Vacuum amplifier of brakes
   10.17. Stoplight switch
   10.18. Anti-blocking system of brakes (ABS)
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


3a942d17

10.8. Main brake cylinder

Removal

PERFORMANCE ORDER
1. Disconnect the electric socket from a tank with brake fluid.
2. Uncover a tank of brake system and, using a syringe, pump out brake fluid.
3. Mark the brake tubes suitable to the main brake cylinder. Arrange pure rags under the main brake cylinder.
4. Unscrew nuts of fastening of brake tubes and take aside from the main brake cylinder brake tubes.
5. Close the ends of tubes the corresponding traffic jams.
6. Unscrew nuts of fastening and remove the main brake cylinder from the vacuum amplifier of brakes together with laying.
7. Take the main brake cylinder from a motor compartment of the car.

Installation

PERFORMANCE ORDER
1. Before installation of the main brake cylinder fill in in it brake fluid and remove air for what fix the main brake cylinder in a vice and close exhaust outlets of the main brake cylinder carving traffic jams.
2. Fill in pure brake fluid in a tank.
3. Unscrew one stopper and, moving the piston in the main brake cylinder, squeeze out from it air.
4. Before an otpuskaniye of the piston screw in into place a carving stopper.
5. Repeat operation on removal of air until the opening does not leave only pure brake fluid without vials of air. Repeat operation on removal of air from the main brake cylinder on the second exhaust outlet.
6. Further installation of the main brake cylinder is made in sequence, the return to removal. Remove air from hydraulic brake system.