Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
- 10. Brake system
   10.1. Introduction
   10.2. Technical characteristics
   10.3. Replacement of brake shoes on disk brakes
   10.4. Support of disk brakes
   10.5. Brake disk
   10.6. Replacement of brake shoes of drum brakes
   10.7. Working brake cylinder
   10.8. Main brake cylinder
   10.9. Brake pipelines and hoses
   10.10. Replacement of the regulator of pressure
   10.11. Pumping of hydraulic brake system
   10.12. Adjustment of the emergency brake
   10.13. Replacement of a cable of the emergency brake
   10.14. Replacement of brake shoes of the emergency brake on back disk brakes
   10.15. Additional brake system
   10.16. Vacuum amplifier of brakes
   10.17. Stoplight switch
   10.18. Anti-blocking system of brakes (ABS)
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


3a942d17

10.15. Additional brake system

GENERAL INFORMATION

Elements of additional brake system

1 – brake valve
2 – brake cable
3 – adjusting nut of a cable
4 – lock-nut
5 – plugs
6 – pin
7 – forelock
8 – U-shaped bracket
9 – cable arm
10 – bolts
11 – bracket of fastening of a cable

Adjustment

PERFORMANCE ORDER
1. Check and if necessary adjust a coupling cable.
2. Install the car on the road with a bias not less than 3 °.
3. Slowly moving on the road with a bias, stop the car and press only a coupling pedal. If the car starts sliding, the cable of additional brake system proslablen means.
4. Moving an adjusting nut, adjust a cable tension.
5. Repeat check of work of additional brake system, having stopped the car on a bias and having pressed a coupling pedal. If necessary repeat adjustment. Do not draw a cable of additional brake system.