Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
- 10. Brake system
   10.1. Introduction
   10.2. Technical characteristics
   10.3. Replacement of brake shoes on disk brakes
   10.4. Support of disk brakes
   10.5. Brake disk
   10.6. Replacement of brake shoes of drum brakes
   10.7. Working brake cylinder
   10.8. Main brake cylinder
   10.9. Brake pipelines and hoses
   10.10. Replacement of the regulator of pressure
   10.11. Pumping of hydraulic brake system
   10.12. Adjustment of the emergency brake
   10.13. Replacement of a cable of the emergency brake
   10.14. Replacement of brake shoes of the emergency brake on back disk brakes
   10.15. Additional brake system
   10.16. Vacuum amplifier of brakes
   10.17. Stoplight switch
   10.18. Anti-blocking system of brakes (ABS)
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


3a942d17

10.5. Brake disk

GENERAL INFORMATION

Arrangement of bolts of fastening of the holder of a support of a forward wheel


Arrangement of bolts of fastening of the holder of a support of a back wheel

Check

PERFORMANCE ORDER
1. Lift respectively a lobby or back part of the car and record on supports. Remove the corresponding wheel.
2. Remove a support and, using a soft wire, tie it to a rack, without disconnecting from it a brake hose.
3. Establish under nuts of fastening of a wheel of a washer 10 mm thick and screw nuts of fastening of a wheel.
4. The indicator of hour type check a beating of a brake disk. Fix the indicator of hour type in any convenient place and, turning a disk, define its beating at distance of 10 mm from the outer edge.
5. Clear a working surface of a brake disk a small emery paper.
6. Slowly turn a brake disk so that it could be considered from two parties. Measure thickness of a brake disk. Wear of a brake disk from blocks has to be in admissible limits. If wear exceeds an admissible limit or there are cracks on a disk, the disk is subject to replacement (the minimum thickness of a brake disk is beaten out on an internal surface of a brake disk – on the right).

Removal

PERFORMANCE ORDER
1. Unscrew nuts of fastening of a wheel with thick washers which were established when checking a beating of a disk.
2. Unscrew two bolts and remove the holder of a support (see rice. Arrangement of bolts of fastening of the holder of a support of a forward wheel, Arrangement of bolts of fastening of the holder of a support of a back wheel).
3. Remove a brake disk.

Installation

PERFORMANCE ORDER
1. Clear a brake disk and establish it into place.
2. Establish the holder of a support and fix bolts.
3. Establish brake shoes and a support.
4. Establish a wheel and lower the car. Several times press a brake pedal that brake shoes nestled on a brake disk.