Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
- 9. Coupling, shaft
   9.1. Technical characteristics
   - 9.2. Coupling
      9.2.1. Coupling cable
      9.2.2. Main cylinder of coupling
      9.2.3. Working cylinder of coupling
      9.2.4. Coupling disk
      9.2.5. Vyzhimna bearing
      9.2.6. Replacement of the needle bearing of an output shaft of a transmission
      9.2.7. Removal of air from hydraulic system of coupling
      9.2.8. The switch of blocking of a starter on a coupling pedal
   + 9.3. Driveshaft
   + 9.4. Power shafts
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


3a942d17



9.2.5. Vyzhimna bearing

Removal

PERFORMANCE ORDER
1. Remove a transmission.
2. Remove brackets of fastening of the vyzhimny bearing.
3. Remove vyzhimny the bearing from an entrance shaft of a transmission.
4. Having pulled a coupling switching off fork, remove it from a spherical head of a support of the lever.
5. Remove a rubber cover and through an opening in a case of coupling take a coupling switching off fork.

Check

PERFORMANCE ORDER
1. Holding the bearing for an external holder, pressing, turn an internal holder of the bearing. If the bearing rotates with noise and unevenly, replace vyzhimny the bearing.
2. Wipe the bearing pure rags and check its state for existence of damages, wear and a crack. Do not wash out the bearing in solvent as it is the bearing of the closed type.

Installation

PERFORMANCE ORDER
1. Apply high-temperature greasing on a coupling switching off cylinder pusher head.
2. Apply high-temperature greasing on the directing plug of the vyzhimny bearing.
3. Apply high-temperature greasing on working surfaces of a fork of switching off of coupling.
4. Apply high-temperature greasing on a spherical nest of a fork of switching off of coupling.
5. Installation is made in sequence, the return to removal.