Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
- 9. Coupling, shaft
   9.1. Technical characteristics
   - 9.2. Coupling
      9.2.1. Coupling cable
      9.2.2. Main cylinder of coupling
      9.2.3. Working cylinder of coupling
      9.2.4. Coupling disk
      9.2.5. Vyzhimna bearing
      9.2.6. Replacement of the needle bearing of an output shaft of a transmission
      9.2.7. Removal of air from hydraulic system of coupling
      9.2.8. The switch of blocking of a starter on a coupling pedal
   + 9.3. Driveshaft
   + 9.4. Power shafts
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


3a942d17

9.2.2. Main cylinder of coupling

Removal and installation

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Disconnect a pusher of the main cylinder of coupling from a coupling pedal. Unscrew a bolt, disconnect a hydraulic hose from the main cylinder of coupling and merge brake fluid in the suitable container.
3. Unscrew nuts of fastening of the main cylinder of coupling to a partition of a motor compartment and remove the main cylinder of coupling.
4. Installation is made in sequence, the return to removal. Remove air from hydraulic system of coupling and check height of installation and a free wheeling of a pedal of coupling.