Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
- 14. Electric equipment
   - 14.1. Electric equipment of a body
      14.1.1. Introduction
      14.1.2. Electric chains
      14.1.3. Detection of not closed chain
      14.1.4. Safety locks
      14.1.5. Chain breakers
      14.1.6. Relay
      14.1.7. Relay of turns and alarm light system
      14.1.8. Multipurpose switches of a steering column
      14.1.9. Ignition lock
      + 14.1.10. Replacement of switches of the dashboard
      14.1.11. Combination of devices
      14.1.12. Radio receiver
      14.1.13. Loudspeakers
      14.1.14. Antenna
      14.1.15. The antenna with the electric drive
      14.1.16. Replacement of bulbs of headlights
      14.1.17. Adjustment of light of headlights
      14.1.18. Headlight
      14.1.19. Replacement of bulbs of an incandescence
      14.1.20. Screen wiper engine
      14.1.21. Sound signal
      14.1.22. Check of a heater of back glass
      14.1.23. Window regulators with the electric drive
      14.1.24. Rear-view mirrors with the electric drive
      14.1.25. Safety airbag
   + 14.2. Electroschemes


3a942d17

14.1.21. Sound signal

GENERAL INFORMATION

Arrangement of the left sound signal

Sound signals are located behind headlights.

If the sound signal does not work, disconnect from it the electric socket and, using additional wires, connect the accumulator to a sound signal.

If the sound signal still does not work, replace it.

If the sound signal does not work, check, whether tension to the socket of a sound signal when pressing the button of a sound signal arrives.

If tension on the socket of a sound signal is absent, check a condition of the relay of a sound signal.

PERFORMANCE ORDER
1. For replacement of a sound signal disconnect the electric socket and unscrew a bolt of fastening of a sound signal.
2. Installation is made in sequence, the return to removal.