Subaru Legacy

since 1990-1998 release

Repair and operation of the car


Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
- 7. Systems of start, ignition
   7.1. Introduction
   7.2. Technical characteristics
   7.3. Check of the accumulator
   7.4. Battery charging
   7.5. Accumulator
   + 7.6. System of ignition
   - 7.7. System of charging
      7.7.1. Generator
      7.7.2. Repair and check of the generator
   + 7.8. System of start of the engine
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


3a942d17

7.7.1. Generator
GENERAL INFORMATION

The generator installed on the engine of 1,8 l
1 – pulley
2 – forward cover
3 – bearing
4 – plate of fastening of the bearing
5 – rotor
6 – stator 		7 – bolt
8 – tension regulator
9 – brushes
10 – a plate with diodes
11 – condenser
12 – back cover

The generator installed on l engines 2,0, 2,2 and 2,5
1 – nut
2 – pulley
3 – forward cover
4 – bearing
5 – plate of fastening of the bearing
6 – screw
7 – rotor
8 – stator
9 – tension regulator
10 – condenser, brushes
 11 – a plate with diodes
12 – bolt
13 – bolt
14 – brush holder
15 – back cover
16 – contact
17 – nut
18 – bolt
19 – coupling bolt

Removal and installation

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Disconnect electric sockets from the generator.
3. Take off a driving belt of the generator.
4. Unscrew adjusting and hinged bolts (are specified by shooters) fastenings of the generator and remove the generator from the engine.
5. Installation is made in sequence, the return to removal. Adjust a tension of a driving belt.