|
Subaru Legacysince 1990-1998 releaseRepair and operation of the car |
|
Subaru of Legasi + 1.1. Identification numbers + 2. Maintenance + 3. Engines + 4. Heating, ventilation + 5. Fuel system + 6. Exhaust system - 7. Systems of start, ignition 7.1. Introduction 7.2. Technical characteristics 7.3. Check of the accumulator 7.4. Battery charging 7.5. Accumulator + 7.6. System of ignition + 7.7. System of charging - 7.8. System of start of the engine 7.8.1. Starter 7.8.2. Replacement of the traction relay + 8. Transmissions + 9. Coupling, shaft + 10. Brake system + 11. Suspension bracket + 12. Steering + 13. Body + 14. Electric equipment |
7.8. System of start of the engine
If the starter does not work in the provision of a key "start of the engine", the following reasons are possible: If damage to an electric chain is suspected, disconnect the accumulator and clear all connections and contacts in a starter power-supply circuit. Repeatedly connect the accumulator and, using the voltmeter, check tension on elements of an electric chain to a starter. If the accumulator and an electric chain in a good shape, remove a food wire from the traction relay and connect to it the voltmeter. Turn the ignition key in the situation "start of the engine". The full tension of the accumulator has to be in this family way. Contacts of the traction relay can be checked by connection of the voltmeter between contact of the traction relay connected to a starter, and the earth. At turn of the ignition key in the situation "start of the engine" the voltmeter has to show tension. In the absence of tension the solenoid of the traction relay is faulty or contacts of the traction relay scorched. If the electric chain and the traction relay are serviceable, so the starter is faulty. |
|