Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
- 3. Engines
   3.1. Technical characteristics
   3.2. Operations on repair of the engine installed in the car
   3.3. Top dead point of the first cylinder
   3.4. Cover of a head of the block of cylinders
   3.5. Inlet collector
   + 3.6. Gear belt and pulleys
   3.7. Replacement of a forward sealing ring of a cranked shaft
   3.8. Replacement of sealing rings of camshafts
   3.9. Camshafts and pushers
   3.10. Heads of the block of cylinders
   3.11. Oil pallet
   3.12. Oil pump
   3.13. Drive flywheel / plate
   3.14. Replacement of a back sealing ring of a cranked shaft
   3.15. Suspension bracket of the power unit
   + 3.16. Capital repairs of the engine
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


: http://maxi-credit.ru/


3.4. Cover of a head of the block of cylinders

Removal and installation

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Pick up the phone of an air inlet and assembly of the air filter for access to the right cover of a head of the block of cylinders.
3. Remove high-voltage wires from spark plugs.
4. Remove the accumulator and a support of the accumulator for access to the left cover of a head of the block of cylinders.
5. Remove a windshield washer reservoir from a motor compartment.
6. Unscrew bolts (are specified by shooters) and uncover heads of the block of cylinders.
7. Installation is made in sequence, the return to removal. Thus it is necessary to establish new laying of a cover of a head of the block of cylinders.