Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
   5.1. Introduction
   5.2. Technical characteristics
   5.3. Removal of pressure in fuel system
   5.4. Check of the fuel pump
   5.5. Fuel pump
   5.6. Fuel separator (only models 4WD)
   5.7. Fuel level sensor
   5.8. Fuel tank
   5.9. Casing of the air filter
   5.10. Accelerator cable
   5.11. Electronic system of injection of fuel
   5.12. Fuel system
   5.13. System of air supply
   5.14. System of electronic control
   5.15. Check of system of injection of fuel
   + 5.16. Check and replacement of elements of system of injection of fuel
   5.17. Turbocharger
   5.18. Check of the executive mechanism of the gate of a turbocharger
   5.19. General check of a turbocharger
   5.20. Removal and installation of a turbocharger
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment





5.3. Removal of pressure in fuel system

PERFORMANCE ORDER
1. Uncover a fuel-filling mouth to level pressure in a tank with the atmospheric.
2. Remove a back seat (the car with a body like "sedan") or a carpet for access to the block of the fuel pump with the fuel level measuring instrument.
3. Disconnect the electric socket (it is specified by an arrow) from the fuel pump.
4. Start the engine in the idling mode to an engine stop therefore pressure in fuel system will decrease to zero.
5. After completion of works on fuel system repeatedly connect the electric socket of the fuel pump.