Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
- 4. Heating, ventilation
+ 4.1. Cooling system
+ 4.2. System of heating
- 4.3. Air conditioning system
4.3.1. Check of the air conditioning system
4.3.2. Coolant addition
4.3.3. Receiver / dehumidifier
4.3.4. Compressor
4.3.5. Condenser
4.3.6. Evaporator
4.4. System of climate control
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment
|
The condenser of the air conditioning system is installed before a radiator.
Removal
| PERFORMANCE ORDER |
| 1. Discharge the air conditioning system. |
| 2. Remove a front grille and unscrew bolts of fastening of a radiator. |
|
|
| 3. Disconnect coolant pipes from the condenser, having unscrewed bolts of fastening of a pipe on the left side of the condenser (drawing at the left) and on the right side of the condenser (drawing on the right). |
|
4. Unscrew bolts of fastening of the condenser. |
| 5. Incline a radiator back and take the condenser from the car. |
|
Installation
Prevention
At installation of the new condenser it is necessary to establish a new receiver a dehumidifier.
| PERFORMANCE ORDER |
| 1. At installation of the new condenser merge from it oil in a measuring test tube. Fill in the same amount of new oil in the new condenser. |
| 2. Install the condenser before a radiator and fix bolts. |
| 3. Connect pipes to the condenser, previously having established on them new sealing rings of round section and having oiled them. |
| 4. Further installation is made in sequence, the return to removal. |
|
|
|
