Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
- 4. Heating, ventilation
+ 4.1. Cooling system
- 4.2. System of heating
4.2.1. Heater fan
4.2.2. Heater radiator
4.2.3. Control panel heater
+ 4.3. Air conditioning system
4.4. System of climate control
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment
|
Heater
1 – heater casing
2 – heater radiator
3 – air supply tubes
4 – a branch pipe of supply of the warmed-up air
5 – gate
6 – gate
7 – gate
8 – gate
9 – gate
10 – the gate of the warmed-up air
11 – lever
12 – gate lever
13 – gate lever
14 – connection lever
15 – lever
16 – main draft
17 – screw
18 – spring
19 – engine of the executive mechanism |
20 – arm of the engine of the executive mechanism
21 – draft of the executive mechanism
22 – draft
23 – draft
24 – holder of draft
25 – bracket
26 – clip
27 – clip
28 – suspension bracket
29 – draft
30 – connector
31 – connector
32 – screw
33 – suspension bracket
34 – lower air duct
35 – plug
36 – lower air duct
37 – draft casing |
Prevention
On some models the safety airbag is installed. Therefore it is necessary to remove a weight wire from the accumulator and to wait at least one minute before work about the sensor of collision or the dashboard to avoid casual expansion of the airbag of safety.
Removal
| PERFORMANCE ORDER |
| 1. Remove a weight wire from the accumulator. |
| 2. Merge cooling liquid from the cooling system. |
| 3. Disconnect hoses of supply of cooling liquid to a heater radiator. |
|
4. Disconnect a cable of adjustment of temperature from a heater radiator. |
| 5. Remove the central console and the dashboard. |
| 6. Separate the heater tube located between a radiator of a heater and the fan of a heater. |
| 7. On models with the air conditioning system remove the evaporator. |
|
8. Unscrew bolts (are specified by shooters). |
| 9. Remove a heater and take it from the car. |
| Unscrew screws, the fixing clips of pipes of a radiator of a heater on the heater case (see rice. Heater). Take a heater radiator from a heater casing. |
|
Installation
| PERFORMANCE ORDER |
| 1. Establish a heater radiator in a heater casing. |
| 2. Install a heater in the car. |
| 3. Establish heater tubules. |
| 4. Repeatedly install the dashboard and the central console. Connect wires, a cable and the vacuum hoses diconnected at removal. |
| 5. Establish a cable of adjustment of temperature. |
| 6. Connect hoses of supply of cooling liquid to a heater. |
| 7. Fill in cooling liquid in the cooling system and connect a wire of mass of the accumulator. |
|
|
|
