Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
- 12. Steering
   12.1. Introduction
   12.2. Technical characteristics
   12.3. Steering wheel
   12.4. Tips of steering draft
   12.5. Replacement of protective covers of steering transfer
   12.6. Steering transfer
   12.7. Pump of the amplifier of a steering
   12.8. Removal of air from system of a steering with the amplifier
+ 13. Body
+ 14. Electric equipment


3a942d17

12.4. Tips of steering draft

Removal

PERFORMANCE ORDER
1. Lift forward part of the car and record on supports. Remove a forward wheel.
2. Record steering draft and unscrew a lock-nut of steering draft on a quarter of a turn. Do not move a lock-nut from this situation as it will serve as a reference point at installation of a new tip of steering draft.
3. At full unscrewing of a lock-nut, using paint, note the provision of a steering tip on a carving of steering draft.
4. Take the forelock and unscrew a nut of fastening of the spherical hinge of a tip of steering thirst for a rotary fist.
5. Using a stripper, take the spherical hinge of a tip of steering draft from a rotary fist.
6. Unscrew a tip of steering draft from steering draft, having counted exact number of turns of a tip of steering draft.
7. Check a condition of a protective cover of the spherical hinge of a tip of steering draft.
8. For replacement of a protective cover of the hinge remove a spring ring.
9. Then remove a protective cover on a pin of the spherical hinge.
10. Wipe the hinge pure rags, apply on it a greasing layer, establish a new cover and fix it a ring.

Installation

PERFORMANCE ORDER
1. Screw a tip of steering draft on steering draft on the same number of turns, as at removal. Thus the lock-nut of a tip of steering draft has to be established on a quarter of a turn of steering draft.
2. Install the spherical hinge of a tip of steering draft in a rotary fist and fix a nut.
3. Tighten a lock-nut of fastening of a tip of steering draft.
4. Establish a wheel and lower the car.
5. Check and, if necessary, adjust corners of installation of forward wheels.