Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
   5.1. Introduction
   5.2. Technical characteristics
   5.3. Removal of pressure in fuel system
   5.4. Check of the fuel pump
   5.5. Fuel pump
   5.6. Fuel separator (only models 4WD)
   5.7. Fuel level sensor
   5.8. Fuel tank
   5.9. Casing of the air filter
   5.10. Accelerator cable
   5.11. Electronic system of injection of fuel
   5.12. Fuel system
   5.13. System of air supply
   5.14. System of electronic control
   5.15. Check of system of injection of fuel
   + 5.16. Check and replacement of elements of system of injection of fuel
   5.17. Turbocharger
   5.18. Check of the executive mechanism of the gate of a turbocharger
   5.19. General check of a turbocharger
   5.20. Removal and installation of a turbocharger
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


3a942d17

5.18. Check of the executive mechanism of the gate of a turbocharger

GENERAL INFORMATION

Check of the executive mechanism of the gate of a turbocharger


Check of increase of pressure of a turbocharger

The gate of a turbocharger provides additional increase of turns of a turbocharger at a low speed without increase of turns at a high speed. The executive mechanism of the gate (solenoid) copes pressure signal received from compressed air at the turbocharger exit.

PERFORMANCE ORDER
1. Remove a pressure head hose from the gate valve.
2. Connect the manual pump to a pressure head hose and create pressure of 0,07 bars and check that draft of the executive mechanism moves (see rice. Check of the executive mechanism of the gate of a turbocharger).
3. If at tests draft of the executive mechanism of the gate does not move, replace the executive mechanism of the gate.
4. Check pressure of increase of a turbocharger. If increase of pressure too big, the engine can knock, and the air will be let out via the safety air valve. Too small increase of pressure reduces engine capacity. For check of increase of pressure warm up the engine up to the normal working temperature and connect a tee with the manometer to a pressure head hose of the soaking-up pipeline (see rice. Check of increase of pressure of a turbocharger).
5. Press a pedal of coupling and increase engine turns to 4600 rpm and check pressure of increase which has to make 0,5 bars.