Subaru Legacy

since 1990-1998 release

Repair and operation of the car


Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
   5.1. Introduction
   5.2. Technical characteristics
   5.3. Removal of pressure in fuel system
   5.4. Check of the fuel pump
   5.5. Fuel pump
   5.6. Fuel separator (only models 4WD)
   5.7. Fuel level sensor
   5.8. Fuel tank
   5.9. Casing of the air filter
   5.10. Accelerator cable
   5.11. Electronic system of injection of fuel
   5.12. Fuel system
   5.13. System of air supply
   5.14. System of electronic control
   5.15. Check of system of injection of fuel
   + 5.16. Check and replacement of elements of system of injection of fuel
   5.17. Turbocharger
   5.18. Check of the executive mechanism of the gate of a turbocharger
   5.19. General check of a turbocharger
   5.20. Removal and installation of a turbocharger
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


3a942d17

5.15. Check of system of injection of fuel
GENERAL INFORMATION

If there was a malfunction in fuel system, at first check that all electric sockets are reliably connected and protected from corrosion. Also check, purity of the air filter, a state and a gap in spark plugs, correctness of adjustment of valvate gaps, a compression in engine cylinders, installation of a corner of an advancing of ignition and purity of hoses of air supply in the engine.

PERFORMANCE ORDER
1. Pick up the air inlet phone from the case of a throttle and check existence of a carbonaceous raid in the throttle case. If necessary, using aerosol solvent, clear a carbonaceous raid.
2. Using a stethoscope, check work of fuel nozzles on presence of clicks during the work of nozzles.
3. If there is a suspicion that the fuel nozzle does not work, connect a LED sampler to contacts of a fuel nozzle and during the operation of the engine check that the LED sampler blinks.
4. Remove the electric socket from a fuel nozzle and check resistance of a fuel nozzle.
5. If actions for check of system of injection do not help to reveal malfunction of fuel system, it is necessary to make check and repair of fuel system at service station.