Subaru Legacy

since 1990-1998 release

Repair and operation of the car


Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
   5.1. Introduction
   5.2. Technical characteristics
   5.3. Removal of pressure in fuel system
   5.4. Check of the fuel pump
   5.5. Fuel pump
   5.6. Fuel separator (only models 4WD)
   5.7. Fuel level sensor
   5.8. Fuel tank
   5.9. Casing of the air filter
   5.10. Accelerator cable
   5.11. Electronic system of injection of fuel
   5.12. Fuel system
   5.13. System of air supply
   5.14. System of electronic control
   5.15. Check of system of injection of fuel
   + 5.16. Check and replacement of elements of system of injection of fuel
   5.17. Turbocharger
   5.18. Check of the executive mechanism of the gate of a turbocharger
   5.19. General check of a turbocharger
   5.20. Removal and installation of a turbocharger
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


3a942d17

5.14. System of electronic control
GENERAL INFORMATION

All information from sensors is analyzed by the ECM block of system of electronic control and on this basis the block defines the corresponding corner of an advancing of ignition and composition of fuel mix. The ECM block operates fuel nozzles, determining the impulse width, that is an interval of time when the nozzle is open to provide richer or poorer fuel mix.