Subaru Legacy

since 1990-1998 release

Repair and operation of the car

Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
   5.1. Introduction
   5.2. Technical characteristics
   5.3. Removal of pressure in fuel system
   5.4. Check of the fuel pump
   5.5. Fuel pump
   5.6. Fuel separator (only models 4WD)
   5.7. Fuel level sensor
   5.8. Fuel tank
   5.9. Casing of the air filter
   5.10. Accelerator cable
   5.11. Electronic system of injection of fuel
   5.12. Fuel system
   5.13. System of air supply
   5.14. System of electronic control
   5.15. Check of system of injection of fuel
   + 5.16. Check and replacement of elements of system of injection of fuel
   5.17. Turbocharger
   5.18. Check of the executive mechanism of the gate of a turbocharger
   5.19. General check of a turbocharger
   5.20. Removal and installation of a turbocharger
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


5.10. Accelerator cable

Removal and installation

1. Remove a casing of the air filter.
2. Disconnect an accelerator cable from the lever of a butterfly valve.
3. In the presence remove a control cable of average speed from a cable arm.
4. Disconnect an accelerator cable cover from an arm, having unscrewed nuts of fastening of a cover.
5. Remove an accelerator cable from the top part of a pedal of management of fuel supply.
6. Take an accelerator cable in a motor compartment.
7. Installation is made in sequence, the return to removal.


1. Moving nuts of fastening of a cover of a cable of an accelerator to an arm, establish sagging of a cable of an accelerator within 10–12 mm.
2. Press against the stop a pedal of an accelerator and check that the butterfly valve opens completely, and at an accelerator pedal otpuskaniye the butterfly valve comes back to a starting position.