Subaru Legacy

since 1990-1998 release

Repair and operation of the car


Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
- 3. Engines
   3.1. Technical characteristics
   3.2. Operations on repair of the engine installed in the car
   3.3. Top dead point of the first cylinder
   3.4. Cover of a head of the block of cylinders
   3.5. Inlet collector
   + 3.6. Gear belt and pulleys
   3.7. Replacement of a forward sealing ring of a cranked shaft
   3.8. Replacement of sealing rings of camshafts
   3.9. Camshafts and pushers
   3.10. Heads of the block of cylinders
   3.11. Oil pallet
   3.12. Oil pump
   3.13. Drive flywheel / plate
   3.14. Replacement of a back sealing ring of a cranked shaft
   3.15. Suspension bracket of the power unit
   + 3.16. Capital repairs of the engine
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


3a942d17

3.13. Drive flywheel / plate

Removal

PERFORMANCE ORDER
1. Lift the car and remove a transmission.
2. Using a marker or paint, note the provision of the leading knot of coupling in relation to a flywheel.
3. Gradually in diagonal sequence, weaken bolts of fastening of the leading knot of coupling, turning each bolt on a half of a turn until it is terminated a spring, and bolts can be unscrewed manually.
4. Remove the leading knot of coupling and a disk of coupling from a flywheel.
5. Record a flywheel from a provorachivaniye, having established a clamp on a gear wreath of a flywheel. Apply combination tags on a flywheel and a cranked shaft.
6. Unscrew bolts and remove a flywheel.

Installation

PERFORMANCE ORDER
1. On models with a mechanical transmission check a flywheel for wear from coupling and a condition of teeths of a gear wreath.
2. Clear the interfaced surfaces of a flywheel and a cranked shaft. Establish a flywheel according to earlier put tags and fix bolts.
3. Record a flywheel from a provorachivaniye and finally tighten bolts of fastening of a flywheel.
4. Further installation is made in sequence, the return to removal.