Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
- 3. Engines
   3.1. Technical characteristics
   3.2. Operations on repair of the engine installed in the car
   3.3. Top dead point of the first cylinder
   3.4. Cover of a head of the block of cylinders
   3.5. Inlet collector
   + 3.6. Gear belt and pulleys
   3.7. Replacement of a forward sealing ring of a cranked shaft
   3.8. Replacement of sealing rings of camshafts
   3.9. Camshafts and pushers
   3.10. Heads of the block of cylinders
   3.11. Oil pallet
   3.12. Oil pump
   3.13. Drive flywheel / plate
   3.14. Replacement of a back sealing ring of a cranked shaft
   3.15. Suspension bracket of the power unit
   + 3.16. Capital repairs of the engine
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


3a942d17

3.11. Oil pallet

GENERAL INFORMATION

Arrangement of bolts of fastening of the oil pallet


Arrangement of bolts of fastening of a tube of an oil receiver

Removal

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator. Lift the car and reliably record on supports.
2. Merge engine oil and unscrew an oil filter.
3. Unscrew nuts of fastening of support of the engine, then, using the load-lifting mechanism, raise the engine on 50 mm.
4. Unscrew the bolts fixing the oil pallet to the block of cylinders of the engine (see rice. Arrangement of bolts of fastening of the oil pallet).
5. Remove the oil pallet from the engine together with laying.
6. If necessary unscrew bolts and pick up the oil receiver phone (see rice. Arrangement of bolts of fastening of a tube of an oil receiver).

Installation

PERFORMANCE ORDER
1. Clear all traces of dirt and oil from the interfaced surfaces of the block of cylinders and the oil pallet.
2. Check a condition of the mesh filter of an oil receiver and, if necessary, clear it.
3. Apply a thin film of sealant on laying of the oil pallet and establish laying on the oil pallet.
4. Install the oil pallet on the block of cylinders and fix bolts, having tightened them the demanded moment.
5. Further installation is made in sequence, the return to removal.