Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
- 14. Electric equipment
   - 14.1. Electric equipment of a body
      14.1.1. Introduction
      14.1.2. Electric chains
      14.1.3. Detection of not closed chain
      14.1.4. Safety locks
      14.1.5. Chain breakers
      14.1.6. Relay
      14.1.7. Relay of turns and alarm light system
      14.1.8. Multipurpose switches of a steering column
      14.1.9. Ignition lock
      + 14.1.10. Replacement of switches of the dashboard
      14.1.11. Combination of devices
      14.1.12. Radio receiver
      14.1.13. Loudspeakers
      14.1.14. Antenna
      14.1.15. The antenna with the electric drive
      14.1.16. Replacement of bulbs of headlights
      14.1.17. Adjustment of light of headlights
      14.1.18. Headlight
      14.1.19. Replacement of bulbs of an incandescence
      14.1.20. Screen wiper engine
      14.1.21. Sound signal
      14.1.22. Check of a heater of back glass
      14.1.23. Window regulators with the electric drive
      14.1.24. Rear-view mirrors with the electric drive
      14.1.25. Safety airbag
   + 14.2. Electroschemes


3a942d17

14.1.25. Safety airbag

GENERAL INFORMATION

Arrangement of the control unit of the safety airbag


Arrangement of the left sensor of collision of system of the airbag of safety


Arrangement of the right sensor of collision of system of the airbag of safety

The safety airbag from the driver is installed as the standard equipment on all models. The safety cushion is established in the center of a steering wheel. The security system joins at inclusion of ignition and becomes more active the delay sensor which is switched on in the electronic control device. At malfunction of a security system on a combination of devices the bulb lights up.

Precautions

When performing any works on the car equipped with a safety cushion during the moving and storage of a safety cushion it is necessary to observe the following precautions:

– not to disconnect the accumulator at the working engine;
– when performing any works on a security system or carrying out electric welding on the car deactivate a security system;
– if the lamp of the alarm system of a security system burns, it is necessary to address immediately on service station;
– it is necessary to transport the safety airbag separately a bag up;
– when transporting not to place a hand on a safety cushion;
– not to throw a safety cushion;
– not to sort a safety cushion;
– to exclude hit on a safety cushion of solvents or the clearing substances;
– not to subject a safety cushion to influence of temperature over 90 °C;
– not to allow contact of a safety cushion with an open flame;
– not to establish on the car a safety cushion with defects or damages.