Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
- 14. Electric equipment
   - 14.1. Electric equipment of a body
      14.1.1. Introduction
      14.1.2. Electric chains
      14.1.3. Detection of not closed chain
      14.1.4. Safety locks
      14.1.5. Chain breakers
      14.1.6. Relay
      14.1.7. Relay of turns and alarm light system
      14.1.8. Multipurpose switches of a steering column
      14.1.9. Ignition lock
      + 14.1.10. Replacement of switches of the dashboard
      14.1.11. Combination of devices
      14.1.12. Radio receiver
      14.1.13. Loudspeakers
      14.1.14. Antenna
      14.1.15. The antenna with the electric drive
      14.1.16. Replacement of bulbs of headlights
      14.1.17. Adjustment of light of headlights
      14.1.18. Headlight
      14.1.19. Replacement of bulbs of an incandescence
      14.1.20. Screen wiper engine
      14.1.21. Sound signal
      14.1.22. Check of a heater of back glass
      14.1.23. Window regulators with the electric drive
      14.1.24. Rear-view mirrors with the electric drive
      14.1.25. Safety airbag
   + 14.2. Electroschemes


3a942d17

14.1.24. Rear-view mirrors with the electric drive

GENERAL INFORMATION

Arrangement of contacts on the electric socket of the switch of adjustment of provision of a mirror and a condition of contacts at various provisions of the switch

For management of the provision of an external rear-view mirror it is used in each mirror on two electric motors.

Adjustment of provision of an external rear-view mirror with the electric drive is possible only after ignition inclusion.

For check of operability of the engine turn on the switch and listen, whether there is a sound of the working engine.

If the engine works, but the mirror does not move probably there is a defect of the drive in a mirror.

If the mirror does not move and the engine does not work, check a safety lock of an electric chain of the drive of a mirror.

If the safety lock is serviceable, remove the switch of adjustment of provision of a mirror from the dashboard and check, whether tension moves to it.

If tension moves to the switch, disconnect from it the electric socket and, using an ohmmeter, check a condition of contacts of the switch depending on position of the switch (see rice. An arrangement of contacts on the electric socket of the switch of adjustment of provision of a mirror and a condition of contacts at various provisions of the switch).