Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
+ 8. Transmissions
+ 9. Coupling, shaft
+ 10. Brake system
- 11. Suspension bracket
   11.1. Introduction
   11.2. Technical characteristics
   + 11.3. The lobby is resistant
   + 11.4. Rack of a back suspension bracket
   11.5. The air self-leveled suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


3a942d17

11.5. The air self-leveled suspension bracket

GENERAL INFORMATION

Arrangement of elements of the air self-leveled suspension bracket on the car


The scheme of the air self-leveled suspension bracket

1 – electromagnetic valve
2 – electromagnetic valves
3 – dehumidifier
4 – air electromagnetic valve
5 – compressor
6 – air electromagnetic valve of loading
7 – air receiver
8 – pressure sensor
9 – control unit
10 – suspension bracket rack
11 – diaphragm
12 – car height sensor
13 – air pipeline

Lobbies and back racks of a suspension bracket with system of self-alignment

1 – nut
2 – plug
3 – sealing ring of round section
4 – samokontryashchayasya nut
5 – fastening of a rack
6 – bracket
7 – sealing ring
8 – corrugated pipe
9 – bolt
10 – adjusting bolt
11 – washer
12 – electromagnetic valve
13 – laying
14 – an air tube for the electromagnetic valve
15 – air tube
16 – electric socket

Elements of a compressor / osushivatel of system of the self-leveled suspension bracket

1 – osushivatel

2 – compressor

3 – laying

4 – washer

5 – compressor arm

6 – compressor pipe

Air receiver of system of the self-leveled suspension bracket

Some models are equipped with the air self-leveled suspension bracket which operates clearance of the car. The control switch of height allows to choose one of two levels of clearance – normal or high. Distinction of height between the normal or high level of clearance makes 40 mm.

The system supports constant clearance, changing pressure in the shock-absorber depending on loading of the car on signals from the sensor of height of the car installed in each spring.

The system consists of four racks of a suspension bracket, the air compressor, the air tank, a dehumidifier and pipelines connecting these components.

Service of the air self-leveled suspension bracket needs to be made only at service station.

During the work on any part of the air self-leveled suspension bracket check that the car is in normal (low) situation, the control switch of height on dashboards is switched off and removed a weight wire from the accumulator.

Replacement of a forward rack

PERFORMANCE ORDER
1. Lift forward part of the car and record on supports. Remove forward wheels.
2. Disconnect air supply tubes.
3. Disconnect the electric socket from the car height sensor.
4. Other operations on removal and installation of a rack with system of self-alignment are similar to operations on removal and installation of a usual rack.

Removal and installation of the compressor and osushivatel

PERFORMANCE ORDER
1. Lift forward part of the car and record on supports. Remove the left forward wheel.
2. Remove forward part of a mudguard.
3. Disconnect air pipes from an osushivatel.
4. Disconnect electric sockets.
5. Unscrew bolts and nuts of fastening and remove the compressor and an osushivatel.
6. Installation is made in sequence, the return to removal.