Subaru Legacy

since 1990-1998 release

Repair and operation of the car



Subaru of Legasi
+ 1.1. Identification numbers
+ 2. Maintenance
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Systems of start, ignition
- 8. Transmissions
   + 8.1. Mechanical transmission
   - 8.2. Automatic transmission
      8.2.1. Introduction
      8.2.2. Technical characteristics
      8.2.3. Diagnostics of leak of operational liquids
      8.2.4. Lever and cable of gear shifting
      8.2.5. Cable of a choice of transfers
      8.2.6. Switch of blocking of a starter and light of a backing
      8.2.7. Replacement of sealing rings
      8.2.8. Check and replacement of support of a transmission
      8.2.9. Adjustment of a brake tape
      8.2.10. Removal and installation of a transmission
+ 9. Coupling, shaft
+ 10. Brake system
+ 11. Suspension bracket
+ 12. Steering
+ 13. Body
+ 14. Electric equipment


3a942d17

8.2.9. Adjustment of a brake tape

GENERAL INFORMATION

Arrangement of the adjusting screw for adjustment of a side play of a brake tape

The adjusting screw for adjustment of a side play of a brake tape is located on the left side of a transmission.

In the movement check work of an automatic transmission and pay attention to the following:

a) If switching of a transmission on more highest transfer comes directly from the first transfer to the third, a gap of a brake tape the too high. Tighten the adjusting screw of a brake tape.
b) If engine turns sharply increase when switching a transmission with the first by the second or about the third by the fourth transfers or there is a big delay when switching on the lowest transfers, a side play of a brake tape too big. Slightly tighten the adjusting screw of a brake tape.
c) If braking when switching a transmission on higher transfer, for example, with the second on the third, a side play of a brake tape the too small is observed. Slightly weaken the adjusting screw.
e) If the transmission repeatedly switches through one transfer, for example, with the second to the fourth or with the fourth to the second, a side play of a brake tape the too small. Weaken the adjusting screw of a brake tape.
PERFORMANCE ORDER
1. Lift the car and record on supports.
2. Holding a wrench the adjusting screw from a provorachivaniye, the second key weaken a lock-nut and after turn of the adjusting screw repeatedly tighten a lock-nut.